Application: Placing a metal part on a plastic base frame in an electronics assembly process
Explanation: Explanation: When installing a metal part, it is necessary to slow down for the last 1 mm. For this reason, in the old placement system, a spring was used at the end of the pneumatic cylinder, and some defects were observed when the spring deteriorated over time. ELECYLINDER used in the new system can control the stance acceleration. Since the target point will be approached more slowly using low acceleration, force control becomes possible and if a stop is experienced before the intended point, it can be concluded that the product is faulty. In addition, since the ELECYLINDER does not need a spring, the defects caused by the spring breakage are eliminated.
